Seatpost Head & Saddle Installation - Felt Tk FRD Owner's Manual Supplement

SEATPOST HEAD & SADDLE INSTALLATION
PARTS
A. (2) Saddle Clamp Upper
B. (2) Saddle Clamp Adjustment Head Half
C. (2) Saddle Clamp Lower
D. (1) Saddle Clamp Binder Nut
E. (1) Saddle Clamp Binder Bolt
REQUIRED TOOLS
- 4mm Allen key
- Torque wrench
- Friction paste
NOTE
See Diagram A1 on next page.
STEPS
1. Place each Saddle Clamp Upper (A) into a Saddle Clamp Adjustment Head Half (B), positioning
them so the hooked surfaces are adjacent and can grip a seatpost rail.
2. Place each Saddle Clamp Lower (C) onto a Saddle Clamp Upper (A), aligning its holes with the
oval-shaped holes of the Saddle Clamp Uppers.
3. Place the bolt (E) and nut (D) threads-down into the holes of the two stacks of Saddle Clamp
parts, aligning tooth on nut to slot in Saddle Clamp Lower.
4. Turn each stack upside down so that the threads face away from your work surface. The
chamfer of the Adjustment Head Half will be placed in contact with the chamfered surface of the
seatpost. Apply friction paste between surfaces.
5. Place one stack thread-side down into the seatpost so the chamfer of the Adjustment Head Half
is in contact with the chamfer of seatpost alloy insert.
6. Holding the remaining stack of pieces in place on the other side of the seatpost, align the bolt
threads with the nut threads and tighten loosely.
7. Slide a saddle (not included) into the saddle clamp assembly beginning from the rear of
the saddle.
8. Once your preferred saddle angle and fore/aft position are established, tighten the saddle
clamp bolt to 10-12 Nm using a torque wrench.
Tk FRD // SEATPOST INSTALLATION 4