Installing Batteries In The Transmitter; Starting; Installing The Vehicle Battery - Silverlit Exost 360 Cross Instructions Manual

Installing batteries in the transmitter:

1 - Open the battery compartment.
2 - Insert 9V batteries, respecting
the + and – polarities.
3 - Replace the cover.
9V
1 x 9V
not included

Installing the vehicle battery:

1 - Make sure the ON/OFF switch is set to OFF.
2 - Open the battery compartment.
3 - Insert AA batteries, respecting the + and – polarities.
4 - Replace the cover.
Power supply
4 x 1,5 V "AA"
not included
+
+

Starting:

1 - If necessary, screw the antenna into the hole on the top
of the remote control.
2 - Extend the antenna fully. Start the car.
3 - To move the car forwards or backwards, push the thrott-
le lever forwards or backwards or press the trigger (depen-
ding on the model).
4 - To turn the vehicle left or right, press the steering lever
to the left or right. Or, depending on the model, turn the
steering wheel or move the 2 levers in opposite directions
to turn.
5 - To stop the vehicle, release the throttle lever.
6 - For best performance, always point the antenna towards
the car.
ENGLISH / EN
ON/OFF
P 5