Chapter 15
Connecting Temporary Terminal and Attaching Peripherals
Temporarily Connecting a Terminal or NMS to the Control Port
Powering Up the Control Terminal
After the node receives power and correctly starts up, the terminal screen appears as shown below. If
the screen is blank or does not display the initial screen, check all connections to the node, and make
sure the terminal and node are receiving power. If the connections are correct, press the Delete key a
few times or cycle the terminal power.
gamma
TRM
YourID:1
IGX 8420
9.2
Aug. 15 1998
13:47 CST
Enter User ID:
Cisco BPX 8600 Series Installation and Configuration
15-4
Release 9.3.0, Part Number 78-10674-01 Rev. D0, July 2001