Pilot Lamp Replacement - Yaesu FT-5100 Technical Supplement

Pilot Lam p Re p lacement
D
Remove the top and bottom covers, as
shown in Case Disassembl y on page 1-2.
D
Pull the knobs off the panel, and unscrew
the ring nuts affixing the mic jack and the
tuning shaft (you may be able to do this
with long-nose pliers, or have your dealer
do it with a special wrench).
D
With a jeweler's screwdriver, remove the
tiny screw on the circuit board just left of the
mic jack, and then remove the circuit board.
D
Referring to Figures 1 and 2 , unsolder the
old bulbs and install the replacements.
D
Reassemble the transceiver in the reverse
order of the above.
PL4001
NR.
nd 90'
PL4002
�
'-- K eep leads straight.
PL4003
sleeve (0. 7 </> X 4mm)
on I wire
Figure 1
FT- 5100 Technical Supplement
Servicing
PL4002
Figure 2
PL4003
2 - 7