55555
Wiring and Turning on the Units Power
Once the wiring has been installed, the power can be turned on. Follow the procedure below for turning on
the power.
Connect VRF network cables to the corresponding U10 USB Network Interface adaptors.
Turn on the power for all connected indoor units.
Turn on the power for all connected outdoor units.
Note
Make sure that USB equipment (USB hub, etc.) that this product is connected to, is not overloaded (power sup-
plied thru the interface does not exceeds the maximum limit).
Turn on the power for BACnet
Copyright© 2010, 2011 Fujitsu General Limited. All rights reserved.
®
Gateway PC, if it is not yet turned on.
16