JVC TS-CL110U Instructions Manual page 3

How to Replace the Lamp
5) Remove the lamp cover.
The lamp is located behind the lamp cover. To access the lamp you will need to remove the
lamp cover. There are three ways to remove it. Please see your television's instruction book
to determine which television type you have. First, loosen the screw located on the lamp
cover using your fingers or a Philips head type screwdriver (cross-head type). Once the screw
has been loosened, gently pull the knob towards you and the panel will come away from the
television. Set it aside.
or or
WARNING:
• DO NOT attempt to remove the assembly until the lamp has fully cooled. If you feel any heat
near the lamp, STOP and wait until the lamp has FULLY COOLED.
• NEVER attempt to remove the lamp with the television plugged into an outlet.
6) Remove the lamp unit.
Using a Philips head screwdriver (cross-head type), loosen the two screws fastening the lamp
unit. When the screws have been loosened, remove the lamp by raising the handle and gently
sliding the unit straight towards you. Place it carefully in the recycling packaging.
7) Install the new lamp unit.
Holding the handle attached to the new lamp unit, slide and push the new lamp straight into the
television and back into the lamp housing area. Do not forget to re-tighten the two screws.
Note: If the lamp does not sit securely in the TV (flat in the lamp housing area), it won't turn on.
Make sure the lamp sits securely and flat in the housing area.
8) Re-install the lamp cover.
Insert the lamp cover in the concave and close the lamp cover. Because the lamp cover has a
role to help prevent the danger of an electrical shock, tighten the screw using your fingers or a
Philips head type screwdriver (cross-head type).
9) Re-install the left speaker panel.
There are two ways to reinstall it. Replace the top part of the left speaker panel first. Fit the top
part of the panel against the TV and gently press it into place. Then, gently press the bottom
part of the speaker panel to fully install it back into place, or to replace the panel, fit the right
side of the panel on the TV and then gently press the left side into place.
10) Re-install the screw to the rear panel.
Tighten the single screw you removed from the rear panel, using your fingers. It is now safe to
plug the television back into the power outlet and begin viewing your television again.
11) Reset the timer which is built into the television.
By using the LAMP TIMER RESET menu on your television, you reset the timer after the lamp
replacement has been completed.
- 3 -