JVC TS-CL110U Instructions Manual page 2

Before replacing the lamp, you will need to purchase a replacement kit, part number:
TS-CL110U. To purchase this kit, consult your dealer or call 1-800-252-5722, or go to
www.jvc.com.
The replacement kit will include the following:
Because the lamp contains a small amount of mercury, it cannot be disposed of with
normal trash.
Hg
Please read these instructions carefully before attempting to replace the lamp. If you feel unsure
about replacing the lamp, call a service technician. Please observe all safety warnings.
If your lamp door is located below on the left side of your television, skip steps No. 3,
4, 9 and 10.
1) Turn off the television.
Press the POWER button on the remote control or TV front panel. Wait until the picture
disappears and the LAMP LED on the front panel has stopped blinking, indicating the lamp has
cooled down completely.
Warning: The cool down process cools the lamp from its operating temperature. This
does not mean the lamp will be cooled down enough to handle safely. We
strongly recommend that you wait at least one hour before attempting to
replace the lamp.
2) Unplug the television.
Disconnect the power cord from the AC outlet. Make sure that the LAMP LED light has stopped
blinking before you unplug the set. Never attempt to replace the lamp with the television
plugged in.
3) Remove the screw from the rear panel.
Next you must remove the screw from the rear panel. The screw is located
under the right rear panel. You will need to remove the screw with your fingers.
4) Remove the left speaker panel.
Next you must remove the left speaker panel located at the bottom of the front panel. There
are two ways to remove it. Please see your television's instruction book to determine which
television type you have. To remove the panel, grab the panel and pulling it towards you, or
pulling it from the left towards you. Set the panel aside.
Note: When removing the speaker panel, in order for the speaker not to fall, hold the speaker
panel securely by the hand, pulling the set slowly and remove.
Replacement Lamp Kit
1 High-Pressure Mercury Lamp, 1 Instruction Manual
For USA only
Hg-LAMP CONTAINS MERCURY! Manage in accord with disposal laws.
Go to: www.lamprecycle.org or call 1-800-252-5722.
How to Replace the Lamp
or
- 2 -