Maintenance And Service - Bosch LR2 Operating/Safety Instructions Manual

To change the volume level or switch off the audio signal, push the
acoustic signal button 3 until the requested volume level is indicated
on the display. At low volume level, the audio signal indicator a
appears on the display with one bar; at high volume level, the
indicator appears with three bars. When the audio signal is set to off,
the indicator goes out.
Independent of the audio signal setting, a short beep sounds at low
volume level each time a button is pressed on the tool.
Working Advice
Marking
When the laser beam runs through the center of the reception area
6, its height can be marked at the center mark 7 right and left on
the tool.
When marking, take care to align the tool exactly vertical (for
horizontal laser beam), or horizontal (for vertical laser beam), as
otherwise the marks are offset with respect to the laser beam.
Attaching with the Magnet (see figure B)
When a positive-lock attachment is not absolutely required, the tool
can be attached to steel parts via the face side using the magnet
plate 5.

Maintenance and Service

Keep the tool clean at all times.
Do not immerse the tool into water or other fluids.
Wipe off debris using a moist and soft cloth. Do not use any
cleaning agents or solvents.
If the tool should fail despite the care taken in manufacturing
and testing procedures, repair should be carried out by an
authorized after- sales service center for Bosch power tools.
In all correspondence and spare parts orders, please always
include the 10-digit article number given on the type plate of
the tool.
ENVIRONMENT PROTECTION
Recycle raw materials & batteries instead of disposing of
waste. The unit, accessories, packaging & used batteries
should be sorted for environmentally friendly recycling in
accordance with the latest regulations.
-11-
1.800.561.8187 information@itm.com
www. .com