Turning The Housing - Beko METPOINT FLM SF53 Installation And Operating Manual

Installation and operating manual

3.1.3. Turning the housing

If the direction of flow changes, the housing can be turned to the required position by undoing the 4 threaded pins with a 1.5 mm
hex key. Align the housing as required and then tighten the threaded pins so they are hand-tight.
NOTE Risk of damage to device
•
•
18
Ensure that the connecting pipes are correctly mounted and that the gaskets are installed properly.
Then use the alignment tool to align the sensor with the direction of flow.
EN
METPOINT SF53
®