Canon VB-C60 Start Manual page 51

3. Enter the user name "root" and default password "VB-C60," and then enter the IP address and
subnet mask you want to set.
If the default gateway is not set, clear the [Enter a default gateway address] check box. When
the setting is complete, click [OK].
Note
There may be cautionary information that should be heeded depending on your operating
environment. See "Notes on Operating Environment" (
setting.
Tip
The factory setting Administrator password is "VB-C60". Be sure to change the password
for security reasons. See "Administrator Password" ( Operation Guide).
The MAC address of this camera is specified at the bottom of the camera (
The factory setting IP address is 192.168.100.1. Set a proper IP address according to the
environment in which the camera is used.
For the IP address, subnet mask and gateway address to be set, contact your Network
Administrator.
4. The progress of setting is shown in a window.
Step 3 Perform Initial Setting of the Camera
P. 1-14) before you perform initial
P. 1-21).
2-11