Table of Contents
Advertisement
Available languages
Available languages
HOW TO USE
CONTROL PANEL
CLEAN TRANSDUCER/
ULTRASONIC MEMBRANE
INDICATOR
WARM MIST SETTING
MIST OUTPUT SETTING
MIST OUTPUT
WARM MIST
NIGHT-LIGHT
POWER ON/OFF BUTTON AND OUT OF WATER INDICATOR
Plug unit into a 120-volt AC electrical outlet. Press the power
humidifier is out of water, the humidifer will turn off and the out of water indicator will illuminate on the
display.
MIST OUTPUT LEVEL
Mist adjusts from the lowest output
the mist output
button. The corresponding mist level will be lit on the display. Each press will increase
by one. Once you reach level 5, it will repeat at level 1.
WARM MIST SETTING
To change the mist temperature from cool to warm mist, press the warm mist
illuminated on the display. To change the mist temperature from warm to cool mist, press the warm mist
button again to turn warm mist off.
NOTE: Once warm mist is selected, it will take approximately 20 minutes to heat up the mist. The Warm
Mist function kills up to 99.99% of Escherichia Coli and Staphylococcus Aureus. Units were allowed to run
to the highest output
7
PROGRAMMABLE HUMIDITY/
CONTINUOUS ON SETTING
OUT OF WATER INDICATOR
AUTO-OFF TIMER SETTING
AUTO-OFF TIMER
PROGRAMMABLE
HUMIDISTAT
CLEAN TRANSDUCER/
ULTRASONIC MEMBRANE
POWER ON/OFF
button to turn unit on. When the
. To increase the mist output, press
button.
will be
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the TotalComfort UHE-WMTF185 and is the answer not in the manual?
Questions and answers
Where is the MAX fill line?
The MAX fill line on the HoMedics TotalComfort UHE-WMTF185 is located on the water tank. When filling, ensure the water level reaches the MAX fill line but does not exceed it.
This answer is automatically generated