Canon PIXMA iP100 Series Quick Start Manual page 75

Cause
Printer port setting does not match the
computer's interface connecting the
printer.
Printer driver is not installed properly.
Error Regarding Automatic Print Head Alignment Is Displayed
Cause
Automatic Print Head Alignment has
failed.
Error Number: 300 Is Displayed
Cause
The printer is not ready.
Printer is not connected properly.
Check the printer port settings.
* In the following instruction, "XXX" signifies your printer's name.
(1)Log on as a user account with administrator privilege.
(2)Click Control Panel, then Printer under Hardware and Sound.
In Windows XP, click Control Panel, Printers and Other Hardware, then
Printers and Faxes.
In Windows 2000, click Control Panel then Printers.
(3)Right-click the Canon XXX icon, then select Properties.
(4)Click the Ports tab to confirm the port settings.
Make sure that a port named USBnnn (where "n" is a number) with Canon
XXX appearing in the Printer column is selected for Print to the following
port(s).
If the port setting is not correct, reinstall the printer driver or change the port
setting.
Note
When printing from the computer through infrared communication, select IR as the
printer port. For details, refer to "The printer port setting is wrong." in "Cannot Print
Properly through Infrared Communication" of the User's Guide on-screen manual.
The printer driver may not be installed properly. Uninstall them following the
procedure described in the PC Printing Guide on-screen manual and reinstall
them following the procedure described in your setup sheet.
See "Eleven flashes: Automatic Print Head Alignment failed." on page 68 in
"Alarm Lamp Flashes Orange" on page 67.
Confirm that the Power lamp is lit green.
If the Power lamp is off, turn the printer on.
While the Power lamp is flashing green, the printer is initializing. Wait until the
Power lamp stops flashing and remains lit green.
If the Alarm lamp is flashing orange, an error may have occurred in the printer.
For details on how to resolve the error, see "Alarm Lamp Flashes Orange" on
page 67.
Make sure that the USB cable is securely plugged in to the printer and the
computer.
If you are using a relay device such as a USB hub, disconnect it, connect the
printer directly to the computer, and try printing again. If printing starts
normally, there is a problem with the relay device.
Consult the reseller of the relay device for details.
There could also be a problem with the USB cable. Replace the USB cable
and try printing again.
Action
Action
Action
Troubleshooting 71