Handlebar Position; Adjusting The Shock Absorber Assemblies - Yamaha XMAX CZD300-A Manual

Instrument and control functions
dent. Be sure to tighten the
screws to the specified torque.
[EWA15511]
1
5
1. Bolt
Tightening torque:
Windshield bolt:
8 N·m (0.8 kgf·m, 5.9 lb·ft)
5. Place the bolt access covers, and
then install the quick fasteners.

Handlebar position

The handlebar can be adjusted to one
of two positions to suit the rider's pref-
erence. Have a Yamaha dealer adjust
the position of the handlebar.
1
1
1. Handlebar
5-22
EAU46833
Adjusting the shock absorber
assemblies
WARNING
Always adjust both shock absorber
assemblies equally, otherwise poor
handling and loss of stability may re-
sult.
Each shock absorber assembly is
equipped with a spring preload adjust-
ing ring.
NOTICE
To avoid damaging the mechanism,
do not attempt to turn beyond the
maximum or minimum settings.
Adjust the spring preload as follows.
Turn the adjusting ring in direction (a)
to increase the spring preload.
Turn the adjusting ring in direction (b)
to decrease the spring preload.
 Align the appropriate notch in the
adjusting ring with the position in-
dicator on the shock absorber.
 Use the spring preload adjusting
tool included in the tool kit to
make this adjustment.
EAU14895
EWA10211
ECA10102