Important Safety Instructions; General Description (Fig. 1) - Philips 1000 Series Quick Start Manual

1
English

IMPORTANT SAFETY INSTRUCTIONS

When using an electric product, basic precautions
should always be followed, including the following:
Read all instructions before using this product.
WARNING
To reduce the risk of burns, fire, electric shock, or
injury to persons:
- Use product only in dry condition. Do not use
while bathing or in a shower.
- Close supervision is required when this product
is used by, on, or near children, or persons with
limited physical, sensory, or mental capabilities
or invalids.
- Use this product only for its intended
household use as described in this manual. Do
not use attachments not recommended by
Philips North America LLC.
- Never drop or insert any object into any
opening.
- Never operate this product if it is not working
properly, after it has been dropped or
damaged, or after the product has been
dropped into water. For assistance call
1-800-243-3050.
- Do not use this product outdoors or operate
where aerosol (spray) products are being used
or where oxygen is being administered.
- Never put the product in direct sunlight or store
at a temperature above 140 °F (60 °C).
- Always check cutters, cutting unit and guards
before using the product. Do not use the
product if cutters, cutting unit or guards are
damaged, as injury may occur.
- Only use the accessories supplied with the
product.
- If product will not be used on a regular basis,
remove the battery to prevent possible damage
due to chemical leakage. If battery does leak,
remove it carefully. Do not allow bare skin to
touch leaking fluid.
- The batteries used in this product may present
a fire or chemical burn hazard if mistreated. Do
not disassemble, heat above 100 °C (212 °F) or
incinerate.
SAVE THESE INSTRUCTIONS
Introduction
Congratulations on your purchase and welcome to
Philips! To fully benefit from the support that
Philips offers, register your product at
www.philips.com/welcome.

General description (Fig. 1)

1 Cutting element
2 Rotary trimmer attachment
3 'Unlocked' indication
4 'Locked' indication
5 Locking indicator
6 Handle
7 Setting indicator
8 'On' indication
9 'Off' indication
10 'Open' indication
11 Battery compartment cover
12 Cleaning brush
Preparing for use
Inserting the battery
Note: Make sure your hands and product are dry
when you insert the battery.
1 To remove the battery compartment cover, turn
it clockwise until the setting indicator points to
the 'unlocked' indication (^) (Fig. 2).
2 Pull the battery compartment cover off the
handle (Fig. 3).
3 Put the battery in the battery compartment (Fig.
4).
Make sure the + and - poles of the battery
point in the right direction.
Note: The product operates on one replaceable
AA 1.5-volt battery (not included).
4 Slide the battery compartment cover back onto
the handle (Fig. 5).
5 Turn the battery compartment cover
counterclockwise until the setting indicator
points to the 'locked' indication (0) (Fig. 6).
1
2
6
7
8
9
10
11
3 4 5
12