Instructions For Type A Tractors; Instructions For Type B Tractors - Craftsman CMXGZBF7124441 Instruction Manual

inStrUCtiOnS fOr tyPe A trACtOrS

Step 1: (fig. 9)
1. Remove any bolts found in the holes indicated in the
illustration.
Fig. 9
REMOVE BOLTS FROM THESE HOLES
Step 2: (fig. 10)
1. Attach the R.H. hanger bracket to the two front empty
holes on the right side of the tractor frame using
two new 3/8" x 1" hex bolts (D), 3/8" lock washers
(R), and 3/8" flat washers (O) with a large 1/2"
washer (N) placed between the hanger bracket
and the tractor frame. TIghTEn. Repeat for the
left side.
2. Go to page 6, figure 13
Fig. 10
3/8" FLAT
WASHER (O)
3/8" LOCK
WASHER (R)
3/8" x 1"
HEX BOLT (D)
R.H. HANGER
BRACKET
FRONT
SUSPENSION
BRACKET
1/2" LARGE
WASHER (N)

inStrUCtiOnS fOr tyPe b trACtOrS

Step 1: (fig. 11)
1. Remove any bolts found in the holes indicated in the
illustration.
Fig. 11
REMOVE BOLTS FROM
THESE HOLES
Step 2: (fig. 12)
1. Attach the R.H. hanger bracket to the three holes shown
on the side of the tractor frame using three 3/8" x 1"
hex bolts (D), 3/8" lock washers (R), 3/8" flat washers (O)
and 1/2" large washers (N). Use 3/8" nylock nuts (M) on
inside of frame if bolts insert freely into holes. Tighten.
2. Repeat on other side.
3. Go to page 6, figure 13
nOTE: Use special 3/8" x 1" thread forming bolts (G) in any
holes that are too small for regular bolts.
Fig. 12
3/8" x 1" HEX BOLT (D)
(OR THREAD FORMING
BOLT (G) IF NEEDED)
3/8" LOCK
WASHER (R)
3/8" FLAT
WASHER (O)
R.H. HANGER
BRACKET
EnglIsh
FRONT
SUSPENSION
BRACKET
3/8" NYLOCK NUT (M)
(IF NEEDED)
1/2" LARGE
WASHER (N)
5