Sealey AP7150C Instructions page 2

4. aSSeMbly
4.1.
Assemble the racking unit following the sequence below, referencing the parts list overleaf. no tools are required
although a mallet is useful for tapping the brackets together.
4.2. Place foot caps onto the bottom of legs H and I. Place
rear shelving brackets A onto the legs. A rubber mallet
can be used to lightly tap the brackets into place in the
keyholes in the legs (note the upright position of the
keyhole).
4.4. Join the lower and upper legs with the connector pins
as shown in fig.3 (note the upright position of the
keyhole).
© Jack sealey Limited
fig.1
4.3. fit shelf bracket B for the side brackets at the same
height as shelf bracket A, then fit shelf bracket E. Fit
brace G as shown above.
fig.3
4.5. fix shelf brackets A so that the top rivet sits in the
upper legs and the lower rivet sits in the lower legs.
repeat with shelf brackets B and E, followed by brace
G, at the same level.
Original Language Version
fig.2
fig.4
AP7150c Issue: 1 - 22/08/12