Hand Microphone Installation - Wouxun KG-XS20G Owner's Manual

Installation and Setup Installation and Setup
External Speaker
The KG-XS20G is equipped with a 3.5mm external speaker jack on the back of the
transceiver. It will accommodate a standard 8-ohm external speaker with a single pin
3.5mm mono audio plug. Stereo plugs will only produce audio from one speaker. Au-
dio accessories with TRRS plugs are not recommended.
PC Programming Port
The KG-XS20G has an RJ45 data port on the rear panel of the unit for use with an
optional PC programming cable such as the Wouxun Mobile Radio USB Programming
Cable (PCO-003). To access the data port, loosen the two screws and remove the pro-
tective cover. Refer to the illustration on page 17 for the exact location of the port.

Hand Microphone Installation

The hand speaker microphone port is located on the lower left side of the front panel.
To connect the hand mic to the transceiver, plug the 8-pin connector into the port and
tighten the screw ring all the way onto the connector. Do not overtighten.
21