Advertisement
5.3.
EDGE TO SURFACE JOINTING (fig.3, fig.4)
5.3.1.
Mark centre line of dowel fixings in surface board and place in position on the work bench (fig.3).
5.3.2.
Lay pre-drilled edge board in position on top of surface board (fig.3) ensuring alignment of edges. Place edge board by adjusting its
position such that the centre line of the dowel holes is dead centre to the relevant guide bush (fig.4) Clamp in place using clamp block.
noTe: use additional clamping if required.
5.3.3.
Locate the jig on the protruding dowels (fig.4) using the relevant slot for the guide bush being used.
5.3.4.
Select dowel size and relevant drill bit. Set the depth gauge on the drill bit to ensure sufficient hole depth to prevent the dowel from
bottoming out on jointing thus preventing the boards from fully meeting.
5.3.5.
To continue drilling further holes, loosen the drill jig clamps and carefully slide the drill jig to it's new position. Tip: spacing can be
achieved by placing a dowel into an existing hole and using a spacer-block between this and the drill jig to set the new location.
iMporTanT: When moving the drill jig location at least one set of clamps must be holding the board in position to prevent movement
and misalignment of the dowels.
environMenT proTecTion
recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
note: it is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
important: no liability is accepted for incorrect use of this product.
warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
sealey group, Kempson way, suffolk Business park, Bury st edmunds, suffolk. ip32 7ar
01284 757500
© Jack sealey limited
fig.3
01284 703534
sales@sealey.co.uk
Original Language Version
fig.4
www.sealey.co.uk
dJ01
issue 1 24/01/18
Advertisement
