Sealey DJ01 Instructions

Thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
refer to Wear protective
instruction gloves
manual
1. saFeTY
Wear appropriate Personal Protective equipment. A full range of Personal Protective equipment is available from your sealey stockist.
9
use the tool in a suitable work area. Keep area clean and tidy and free from unrelated materials and ensure that there is adequate lighting.
9
secure any unstable workpieces with a clamp, vice or other adequate holding device.
9
do noT over-reach. ensure the floor is not slippery and wear non-slip shoes.
8
do noT use the tool for a task it is not designed to perform.
8
do noT get the tool wet or use in damp or wet locations.
8
do noT hold unsecured work in your hand.
8
do noT operate the tool if any parts are missing or damaged as this may cause failure and/or personal injury.
8
do noT operate the tool when you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
2. inTroducTion
i
Jig and clamp dowelling set ideal for making accurate 6, 8 and 10mm dowel holes/joints in mdf and wood. suitable for a number of
different styles of dowel joint including edge-to-edge, edge-to-corner and edge-to-surface. set includes aluminium dowelling jig, alignment
clamps, 60 dowel pins and three drill bit depth stops.
3. speciFicaTion
i
model no: ......................................................................dJ01
dowel sizes ............................................. 6mm, 8mm, 10mm
suitable thickness mdf/Wood ..................... 12mm to 36mm
4. conTenTs
5. operaTion
noTe: these instructions are guidelines only and cannot cover all aspects of creating perfect joints. it is suggested that the use of a
set square, spirit level and additional clamping will enhance the final product. All cuts on the materials to be dowelled together must be
square and true or errors will compound and affect the quality of the joint. If materials to be joined are not uniform and consistent in
thickness, errors may occur in the alignment of jointed surfaces
noTe: There are three different common forms of dowelled joint: 'Edge to Edge', 'Edge to Corner' and 'Edge to Surface'.
5.1. EDGE TO EDGE JOINTING (fig.1)
5.1.1. Clamp the first board in position on the work bench using drill jig (fig.1.A) and clamp block (fig.1.B) thus setting the location for the first
dowel hole.
5.1.2. Rest second board onto drill jig and clamp block platforms and secure with upper clamps (fig.1.C). Tip: support the upper board
securely so that the boards lie parallel to each other and ensure that edges are in line.
© Jack sealey limited
instructions for
universal dowelling jig
model no:
Wear eye Wear face Wear protective
protection mask
Original Language Version
dj01
clothing
dJ01 issue 1 24/01/18