Advertisement
※If you are using a 3.5-inch disk model server:
This product is shipped with a cylinder lock installed. If you do not need this lock,
remove it according to the following procedure.
1. Remove the Screw 1.
2. Open the cylinder lock using the key.
3. Remove the Screw 2, then remove the cylinder lock.
4. Widen the clearance between the accent cover and the chassis, and remove the accent
cover by pulling up it.(①)
5. Stick the blindfold label so that non-adhesive portion of the label covers the key hole,
as shown in the figure below.
6. Install the provided accent cover (without holes), as shown in the figure below.
4
Accent cover
Cylinder lock
Screw 1
5
①
Adhesive portion
Screw 2
Blindfold label
Non-adhesive portion
27
Come off easily.
Be careful not to drop.
6
Advertisement
