Sealey APLHT Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE
PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
1.1. GENERAL SAFETY
WARNING! Ensure Health & Safety, local authority, and general

workshop practice regulations are adhered to when using this
cabinet.
Keep the work area clean, uncluttered and ensure there is

adequate lighting.
Keep the cabinet clean and tidy in accordance with good workshop

practice.
Keep children and unauthorised persons away from the work area.

DO NOT use this cabinet for any purpose other than that for which

it is designed.
DO NOT place the cabinet in a damp or wet location or an area

where there is condensation.
DO NOT clean the cabinet with any solvents which may damage

the surfaces or the protective coating.
2. INTRODUCTION
Lockable storage unit for long tools, such as prybars, long reach
screwdrivers and breaker bars. Hangs on side of rollcab and can be
fastened securely to side for added security. A range of different diameter
support holes provide great versatility of storage options. Supplied with lock
and two keys.
3. SPECIFICATION
Model No:
Overall Size W x D x H:
Support Hole Ø x Quantity:
4. ASSEMBLY
4.1. Fit foam pads to back of the side cabinet to prevent damage to the rollcab.
4.2. The side cabinet can be hung from the rollcab, but it is recommended that the side cabinet is secured to the rollcab, using the two self
tapping screws and two flat washers provided.
4.3. Hang the side cabinet on the rollcab and open it up. Ensure it is centrally positioned and mark the intended position of the holes to be
drilled. Refer to fig.2.
4.4. Remove the side cabinet and drill the two holes in to the roll cab using a 4.8mm (3/16") drill bit.
4.5. Re-hang the side cabinet and secure to the rollcab using the two self tapping screws and two flat washers provided.
© Jack Sealey Limited
INSTRUCTIONS FOR:
SIDE CABINET FOR LONG HANDLE TOOLS
- RED/BLACK
MODEL No's:
APLHT/APLHTB
410 x 90 x 272mm
25mm x 6, 17mm x 4, 15mm x 16
Original Language Version
APLHT/APLHTB
Fig.2
Fig.1
Fig.3
APLHT/APLHTB Issue: 2 - 24/09/14