Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Toro Manuals
  4. Lawn Mower Accessories
  5. 136-9125
  6. Installation instructions manual

Toro 136-9125 Installation Instructions Manual

Belt cover kit fwd recycler lawn mower
Hide thumbs
1
2
3
4
5
6
7
8

Advertisement

Quick Links

Download this manual
Belt Cover Kit
FWD Recycler
Model No. 136-9125
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Upper belt cover
Lower belt cover
Bolt (1/4 x 1.33 inches)
Engine-mount bolt (3/8 x 1 inch)
WARNING
The blade is sharp; contacting the blade can
result in serious personal injury.
Wear gloves when servicing the blade.
Preparing the Machine
1. Shut off the engine and wait for all moving parts
to stop.
2. Disconnect the spark-plug wire from the spark
plug and remove the electric-start button (if
present).
3. Tip the machine onto its side with the air filter up.
4. Use a block of wood to hold the blade steady
(Figure
1).
5. Remove the blade, saving all mounting hardware
(Figure
1).
© 2017—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
Lawn Mower
Qty.
1
1
Install the kit.
2
2
Register at www.Toro.com.
Figure 1
6. Remove the belt from the blade drive and then
remove and retain the blade drive
Original Instructions (EN)
All Rights Reserved *3414-416* B
Printed in the USA
Form No. 3414-416 Rev B
Installation Instructions
Use
(Figure
g206911
2).

Advertisement

loading

Related Manuals for Toro 136-9125

Summary of Contents for Toro 136-9125

  • Page 1 Form No. 3414-416 Rev B Belt Cover Kit FWD Recycler ® Lawn Mower Model No. 136-9125 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Description Qty. Upper belt cover Lower belt cover Install the kit.
  • Page 2 g207687 Figure 2 1. Belt 2. Blade drive 7. Remove and discard the metal belt guide and 2 corresponding bolts (Figure g212481 Figure 4 Model 20339 shown; appearance of machine varies 1. Upper belt cover (discard) 2. Upper belt-cover bolts (retain) 9.

  • Page 3: Installing The Kit

    Installing the Kit 3. Install the blade drive and route the belt around it as shown in Figure 1. Install the 2 engine-mount bolts (3/8 x 1 inch) and torque them to 46 N∙m (34 ft-lb); refer to Figure g207687 Figure 7 1.

  • Page 4: Installing The Blade

    Installing the Blade Important: You will need a torque wrench to install the blade properly. If you do not have a torque wrench or are uncomfortable performing this procedure, contact an Authorized Service Dealer. 1. Install the new blade and all mounting hardware (Figure g024443 Figure 9...
  • Page 5 Template Important: If you are printing this from www.Toro.com, ensure that it is printed at 100% scale and that the distance from A to B is 1 inch: g206972 1. 3.1 mm (0.12 inch) 3. 1.5 mm (0.06 inch) 5. 79 mm (3.11 inches) 2.
  • Page 6 Notes:...
  • Page 7 Notes:...