Emg Patches; Wireless Printer Setup; Before You Begin; Set Up The Printer On Your Wireless Network - LABORIE Goby Owner's Manual

3.3.4 EMG Patches

Once the patient's skin is properly prepared, apply EMG patches as directed below.
NOTE: The patient's anal area should be clean, dry and free of hair.
1. Snap the electrode patches onto the 3 EMG leads.
2. Place two electrodes peri-anally at the 10 o'clock and 2 or 3 o'clock positions. Place as close as possible to the
anus for pelvic floor muscle readings. Place the third electrode on a bony prominence such as the patient's hip
bone or knee (Figure 15).
3. Secured each electrode with an additional piece of surgical tape. If the electrodes detach, dry the skin and apply
new surgical tape.
3.4 W
IRELESS

3.4.1 Before You Begin

Ensure the following:
•
The wireless network is set up and working properly.
•
The printer and the computers that use the printer are on the same network (subnet).
While connecting the printer, you might be prompted to enter the wireless network name (SSID) and a wireless password.
•
The wireless network name is the name of your wireless network.
•
The wireless password prevents other people from connecting to your wireless network without your
permission. Depending on the level of security required, your wireless network might use either a WPA
passphrase or WEP key.
If you have not changed the network name or the security passkey since setting up your wireless network, you can
sometimes find them on the back or side of the wireless router.
If you cannot find the network name or the security password or cannot remember this information, see the
documentation provided with your computer or with the wireless router. If you still cannot find this information, contact
your network administrator or the person who set up the wireless network.

3.4.2 Set Up the Printer on Your Wireless Network

To set up the printer on your wireless network use the Wireless Setup Wizard from the printer control panel display to set
up wireless communication.
1. On the printer control panel display, from the Home screen, touch
2. Touch (Settings).
3. Touch Wireless Setup Wizard or Wi-Fi Protected Setup.
4. Follow the display instructions to complete the setup.
If you are already using the printer with a different type of connection, such as a USB connection, follow the instructions in
Change the connection type on page 24 to set up the printer on your wireless network.
LABORIE Goby Owner's Manual GOBY-UM02
Anal sphincter

Figure 15: Electrode Placement Diagram

P S
RINTER ETUP
Ground patch on
bony prominence
Active patches at 10
o'clock and 3 o'clock
(Wireless).
22