Mount earpiece and metal frame ................12 Mount domesheet .......................13 Mount display assembly on D-cover .................13 Mount screws ......................14 Mount keymat and A-cover assembly ...............14 Insert RF Plug ......................15 Place battery .......................16 Mount B-cover assembly ...................16 Nokia Corporation Issue 1 05/2003 Confidential Page 3...
RH-21 handsets. Remove B-cover 1 Turn phone off 2 Remove the B-cover by pushing the button (indicated by arrow) 3 Lift the B-cover up as shown by the arrows. Nokia Corporation Issue 1 05/2003 Confidential Page 5...
Place thumb under the edge of the A-cover and fingers on top of the A-cover, then pull gently until it snaps. Once lifted, ensure that the keymat does not fall out of the A-cover. Remove screws Unscrew the six screws as indicated. Nokia Corporation Confidential Page 6 Issue 1 05/2003...
Note: Use screwdriver size 2.50 – 3.50 mm. 1 Turn screwdriver at snaps only on one side 2 When removing the metal frame, be careful not to damage the four springs in the corners 3 Remove earpiece Nokia Corporation Issue 1 05/2003 Confidential Page 7...
RH-21 Disassembly/Assembly CCS Technical Documentation Remove PWB assembly Lift the PWB as indicated in the following drawing. Then, place the PWB on ESD table with LEDs on top. Nokia Corporation Confidential Page 8 Issue 1 05/2003...
When working with the PWB, always use a repair jig. Remove components from D-cover assembly The following components are removable: 1 Power key 2 Battery connector 3 SALT speaker (see diagram) 4 Vibra 5 Bottom connector Nokia Corporation Issue 1 05/2003 Confidential Page 9...
2 Place metal frame on lightguide — be careful about the springs in each of the four corners 3 Push the metal frame down (indicated with arrows in drawing below) until it snaps on Nokia Corporation Confidential Page 12 Issue 1 05/2003...
When mounting the domesheet, use the two holes indicated as guide. Mount display assembly on D-cover 1 Place the display assembly in the D-cover 2 Push the display assembly down (indicated by arrows in the drawing below) until it snaps on Nokia Corporation Issue 1 05/2003 Confidential Page 13...
Fasten the screws in the sequence indicated in the following diagram. Be sure to use a torx #6 screwdriver. Note: Max torque 28Ncm at 500-600RPM. Mount keymat and A-cover assembly 1 Place keymat 2 Push down the A-cover until it snaps on Nokia Corporation Confidential Page 14 Issue 1 05/2003...
Slide battery under the hooks in the D-cover. Mount B-cover assembly 1 Place B-cover assembly on D-cover 2 Push the B-cover in the direction indicated by the arrow in drawing below until the B-cover snaps on Nokia Corporation Confidential Page 16 Issue 1 05/2003...