Maintenance; Recommended Accessories - DeWalt DCT410 Instruction Manual

12v max* cordless inspection camera; 12v max* cordless dual lens inspection camera
Hide thumbs Also See for DCT410:
Table of Contents

Advertisement

Available languages

Available languages

To extend battery life, make sure to turn both the screen
and the handle set off when not in use.
Make sure the screen is fully charged before operation.

MAINTENANCE


WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Troubleshooting (Fig. D)
Make sure the 12V Max* battery is charged.
Make sure the screen is fully charged.
Make sure the screen is always attached to the handle
set. The picture may freeze if you attempt to remove
the (screen) from the handle set while taking a photo
or video.
-
Make sure the battery is installed on the handle set
when in use.
-
Make sure the camera cable is attached to the
handle set properly.
-
Make sure the handle set is turned on as well as
the screen.
-
Make sure the back of the handle set is not covered
with debris so the screen slides on easily and no
damage to the screen occurs.
If the screen freezes or won't turn on, insert a small
object (i.e., paper clip end) into the reset button
located on the back of the screen.
-
If the picture is dim, roll the brightness control
switch to brighten the LED light.
Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.
Accessories

WARNING: Since accessories, other than those
offered by D
WALT, have not been tested with this
e
product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only D
recommended accessories should be used with
this product.
Recommended accessories for use with your tool
are available at extra cost from your local dealer or
authorized service center. If you need assistance in
locating any accessory, please contact D
Tool Co., 701 East Joppa Road, Towson, MD 21286, call
1-800-4-D
www.dewalt.com.

Recommended Accessories

Camera cable: 17 mm diameter, DCT4101
Camera cable: 9 mm diameter, DCT4102
Camera cable: 5.8 mm diameter, DCT4015
Camera cable, dual lens: 9 mm diameter, DCT4106
3' (0.91 m) cable extension: 17 mm diameter, DCT4103
Hook, magnet and mirror
Repairs
The charger, battery pack, inspection camera and camera
cable are not serviceable.

Register Online
Thank you for your purchase. Register your product now for:
WARRAnTY sERViCE: Registering your product will
help you obtain more efficient warranty service in case
there is a problem with your product.
COnFiRMATiOn OF OWnERshiP: In case of
an insurance loss, such as fire, flood or theft, your
registration of ownership will serve as your proof
of purchase.
 27 
FOR YOUR sAFETY: Registering your product will
allow us to contact you in the unlikely event a safety
notification is required under the Federal Consumer
Safety Act.
Register online at www.dewalt.com/register.
Three Year Limited Warranty
D
WALT will repair, without charge, any defects due to
e
faulty materials or workmanship for three years from
the date of purchase. This warranty does not cover part
failure due to normal wear or tool abuse. For further detail
of warranty coverage and warranty repair information,
visit www.dewalt.com or call 1-800-4-D
433-9258). This warranty does not apply to accessories
or damage caused where repairs have been made
or attempted by others. THIS LIMITED WARRANTY IS
GIVEN IN LIEU OF ALL OTHERS, INCLUDING THE IMPLIED
WARRANTY OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE, AND EXCLUDES ALL INCIDENTAL
OR CONSEQUENTIAL DAMAGES. Some states do not allow
limitations on how long an implied warranty lasts or the
exclusion or limitation of incidental or consequential
damages, so these limitations may not apply to you. This
WALT
e
warranty gives you specific legal rights and you may have
other rights which vary in certain states or provinces.
In addition to the warranty, D
by our:
WALT Industrial
e
D
WALT will maintain the tool and replace worn parts
e
caused by normal use, for free, any time during the first year
after purchase.
WALT (1-800-433-9258) or visit our website:
e
WARNING: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement, when
applicable) should be performed by a D
service center or a D
WALT authorized service center.
e
Always use identical replacement parts.
WALT tools are covered
e
1 YEAR FREE sERViCE
English
WALT factory
e
WALT (1-800-
e
13

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dct411Dct412Dct415

Table of Contents