Tablet Keypads; Wireless Device Diagnostics; Wired Device Diagnostics - Pyronix ENFORCER V11 Programming Manual

TABLET KEYPADS

This menu shows the IP addresses allocated to the tablets communicating with the control panel. There can be a
maximum of 4 communicating with the panel at any one time.

WIRELESS DEVICE DIAGNOSTICS

Press b or h to scroll to 'DIAGNOSTICS?' . Press .
1.
'Wireless Devices' . Press .
2.
'View Inputs': To view each zone status, press .
3.
Use [ or ] to choose which zones to view. Press .
4.
5. The status of each zone will be shown.
Press h twice to exit, and h again for the next sub-menu item.
6.
'View Input Signal Strength': To view each zones signal strength press .
7.
Use [ or ] to choose which zones to view. Press .
8.
9. The status of each zone will be shown
Press h twice to exit, and h again for the next sub-menu item.
10.
11. Repeat the above for 'View Bells Signal Strength' , and 'View Arming
Station Signal Strength' .
'View Inputs Battery Status':. Press .
12.
Use [ or ] to choose which zones to view. Press .
13.
14. The status of each zone will be shown.
Press h twice to exit, and h again for the next sub-menu item.
15.
Repeat the above for 'View Bells Battery Status' , and 'View Arming Station
16.
Battery Status'
'Wireless Dual Frequency Menu' . To view Dual Frequency menu
17.
information. Press .
Press h to exit.
18.

WIRED DEVICE DIAGNOSTICS

Press b or h to scroll to 'DIAGNOSTICS?' . Press .
1.
Press h until 'Wired Devices' is displayed:. Press .
2.
'View Inputs': To view each zone status, press .
3.
'Endstation Inputs': To view each zone status on the I/O board, press .
4.
5. The status of each zone will be shown:
Hint: Press  again to view each zone individually, and the resistance readings.
Press h twice to exit, and h again for the next sub-menu item.
6.
7. Repeat the above for 'ZEM Inputs' .
'View PSUs': To view the power supply information press .
8.
'Endstation PSUs': The voltage will be displayed. Press . Press  to
9.
view the power supply information for ZEMs, output modules, keypads and
readers.
Press h twice to exit.
10.
36
ENFORCER V11 PROGRAMMING GUIDE