Table of Contents
Advertisement
headboard bracket installation guide (optional)
STEP 1
a .) Align the hole in the bracket to the brass sleeve into which the leg
threads . Hold the bracket in place and screw the leg into the base
until it is snug . DO NOT OVERTIGHTEN. Too much force may cause
the leg to spin freely .
b .) Align the tab with the hole in the frame (located towards the foot of
the base) and use a short bolt, washer and wingnut to secure the
bracket . Make sure the bolt is tight .
18
Headboard Brackets are an optional accessory and are not included.
A hex key is included with the accessory kit to complete installation.
STEP 2
a .) Measure the distance between the mounting holes on the
headboard and install the T-Bracket to accommodate the
headboard .
b .) To install the T-Bracket, slide the T-Bracket through the end
of the headboard bracket . Align the flat side of the T-Bracket
plate to the mounting holes on the headboard .
c .) Secure T-Bracket in place by inserting two short screws
through top of bracket . Use hex key to tighten screws .
STEP 3
Connect your headboard to the attachment plate using the
remaining long screws or hardware that came with your
headboard. The heads of the bolts will face outward. Use hex
key to tighten bolts.
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Motion Air and is the answer not in the manual?
Questions and answers
power adapter blinking control box not luminated
The control box is not illuminated because there may be an issue with the power connection. The power adapter blinking could indicate a power problem. To resolve this, check that the input and power cords are properly connected. Try plugging the bed base into a different electrical outlet or test the current outlet with another working appliance. Using a grounded electrical surge protector is recommended. If the issue persists, unplug the base for one hour to reset the electronic components.
This answer is automatically generated