Installing Your Appliance; Proper Positioning - Blomberg MCN 5410 User Manual

99635791EN.qxd 03/03/05

1 1 / INSTALLING YOUR APPLIANCE

6 6 . . 4 4
• • PROPER POSITIONING
Your appliance should be positioned so that
the plug-in unit is accessible.
The distance between the edge of your
appliance and the side and rear walls (or par-
titions) must be at least four centimetres (area
A).
Your appliance can be easily integrated above
a cabinet, an oven or a build-in-ready house-
hold appliance. You must simply ensure that
the air intakes and air outlets are clear (See
"Description of Your Appliance" section).
BUILD-IN
• •
Follow the diagram above.
Glue the foam seal underneath your appliance
by following the outline of the worktop upon
which your appliance will rest. This will allow
you to achieve an airtight seal with the work-
top.
Attach the clips to the hob.
13:51 Page 36
5 5 8 8
4 4 9 9
A
Tip
If your oven is located below your
hob, the hob's thermal safety measures for-
bid the simultaneous use of the hob and the
pyrolysis program of your oven.
Your hob is equipped with an anti-overhea-
ting safety device.
This safety can be activated, for example,
when the hob is installed over an oven that
is not sufficiently insulated. If this occurs, a
series of small lines appear in the control
panel. In this case, we recommend that you
increase the ventilation of your hob by crea-
ting an opening in the side of your cabinet
(8 cm x 5 cm)
oven insulation kit (reference 75X1652) that
is available from the Post-Sales Service
Department.
You must ensure that the air intakes
located under your cooking appliance
remain clear at all times.
For all types of installation, your induction
hob needs proper ventilation.
36
5 5 1 1
5 5 6 6
and/or that you install the
Warning