Troubleshooting; Soft Reset; Reset Pairing; Reset To Factory Settings - Cardo Systems PACKTALK SLIM Manual

5. TROUBLESHOOTING

5.1 SOFT RESET

If your PACKTALK SLIM stops responding, reset it in one of these ways:
Turning it off and then on again (see
●
Using the supplied USB cable, connect your unit to the computer or wall charger for 30 seconds.
●

5.2 RESET PAIRING

This option deletes all paired units and devices.
To reset pairing:
1. Confirm your unit is in Standby Bluetooth intercom mode (LED flashes blue slowly).
If your unit is not in Bluetooth intercom mode, tap
between Intercom modes
2. While in standby mode, press
3. When the LED flashes red, press
The LED flashes purple 5 times slowly, confirming that pairing has been reset.

5.3 RESET TO FACTORY SETTINGS

This option deletes all paired units, devices and all configuration settings.
To perform a factory reset through the unit:
1. Check that your PACKTALK SLIM is in Standby (see
2. Simultaneously press

5.4 FAQ

Additional answers to common problems can be found at www.cardosystems.com/support/packtalk-slim/.
Getting Started
on page 20.
for 5 seconds.
and for 2 seconds.
+ + for 5 seconds.
on page 5).
and . For more information see,
PACKTALK SLIM LED Indications
21
Switching
on page 27).