All rights reserved. No part of this publication may be reproduced, stored in a retrieval system or transmitted, in any form or by any means, electronic, mechanical, photocopying, or otherwise without the prior permission of Philips. Published by WO 0472 Service PaCE...
EN 2 EM5.2E AA Technical Specifications, Connections, and Chassis Overview 1. Technical Specifications, Connections, and Chassis Overview Index of this chapter: 1.2.1 Top Control and Front / Side Connections 1.1 Technical Specifications 1.2 Connection Overview TOP CONTROL (for PV2 styling) 1.3 Chassis Overview...
Page 3
Technical Specifications, Connections, and Chassis Overview EM5.2E AA EN 3 Aerial - In 19 - CVBS - out 1 V_pp / 75 ohm - IEC-type Coax, 75 ohm 20 - Y / CVBS - in 1 V_pp / 75 ohm...
Page 4
EN 4 EM5.2E AA Technical Specifications, Connections, and Chassis Overview Chassis Overview CRT PANEL TOP CONTROL PANEL SIDE I/O PANEL SMALL SIGNAL BOARD MAINS SWITCH PANEL LARGE SIGNAL PANEL I/O 3rd SCART DC-SHIFT (optional) (ONLY FOR PV02 STYLING) VDAF PANEL E_14590_017.eps...
Directions for Use EM5.2E AA EN 7 3. Directions for Use You can download this information from the following website: http://www.philips.com/support...
EN 8 EM5.2E AA Mechanical Instructions 4. Mechanical Instructions Index of this chapter: 5. When all four clips are pushed down, the back cover can 4.1 Service Connector (for ComPair) be removed. 4.2 Set Disassembly 4.3 Service Positions 4.4 Assies/Panels Removal 4.5 Set Re-assembly...
Page 7
Mechanical Instructions EM5.2E AA EN 9 Service Positions 4.3.3 Solder Side LSP This chassis has several predefined service positions, for better accessibility. They are explained below in more detail. 4.3.1 Solder Side 'I/O 3rd SCART' panel (for PV02 styling - 9319...
Page 8
EN 10 EM5.2E AA Mechanical Instructions SCAVEM bracket. Lift the Auto-SCAVEM bracket slightly up, and at the same time bend the top a little away from the tuner. Now, push the bracket into the direction of the CRT, and lift it out of the LSP-bracket.
Page 9
Mechanical Instructions EM5.2E AA EN 11 4.4.2 Side-I/O Assy/Panel 4.4.4 DAF Assy/Panel CL 16532044_011.eps 150501 Figure 4-13 DAF-module CL 16532149_069.eps 061201 1. Remove the fixation screw (1) (if present). 2. Push down the fixation clamp (2), and pull the complete Figure 4-11 Side I/O assy/panel bracket at the same time away from the CRT (3).
(SAM) offer several features for the service technician, while corner of the screen. the Customer Service Mode (CSM) is used for communication between a Philips Customer Care Centre (P3C) and a How to navigate customer. When you press the "MENU" button on the RC transmitter, the...
Page 11
This will give Time TXT Broadcaster TXT header time from the selected the Philips Service department an extra possibility for preset. diagnosis (e.g. when Development asks for this). Time 8/30 F1 Broadcaster UTC time from 8/30 Format 1.
Page 12
EN 14 EM5.2E AA Service Modes, Error Codes, and Fault Finding How to exit SAM RIGHT" keys on the RC-transmitter after pressing the Use one of the following methods: "MENU" button and selecting "PICTURE" and • Press the "MENU" button on the RC-transmitter, or "CONTRAST".
Page 13
Service Modes, Error Codes, and Fault Finding EM5.2E AA EN 15 (average signal) and to 255 (bad signal). For some • AVL. Indicates the last status of AVL (Automatic Volume software versions, the noise figure will only be valid when Level): "ON"...
Page 14
5.4.1 Introduction Under normal circumstances, a fault in the power supply, or an ComPair (Computer Aided Repair) is a service tool for Philips error during start-up, will switch the television to protection Consumer Electronics products. ComPair is a further mode. ComPair can take over the initialisation of the television.
Page 15
Service Modes, Error Codes, and Fault Finding EM5.2E AA EN 17 Table 5-2 Stepwise start-up table Error Codes Display Enabled 5.5.1 Introduction State Description mode protection Low power standby: 5V2/3V3 present, None The error code buffer contains all detected errors since the last uP in standby-mode time the buffer was erased.
Page 16
EN 18 EM5.2E AA Service Modes, Error Codes, and Fault Finding Table 5-3 Error table. Error Device Description Def. item Defect. module indication Diagram M24C32 NVM, spontaneous blinking error 1 7011 Control Hfail Protection Horizontal Flyback protection Horizontal Flyback SAA4978...
Page 17
Service Modes, Error Codes, and Fault Finding EM5.2E AA EN 19 of the inputs of the HOP, the relevant error bit in the HOP register is set to "high". If this error bit is still "high" after 1 s, the...
Page 18
EN 20 EM5.2E AA Service Modes, Error Codes, and Fault Finding 5.8.3 ComPair Take care not to touch the "hot" heatsink while disconnecting the SSB, despite the fact that the mains cord is out of the mains This chassis does not have an IR transmitting LED (as in MG- socket.
Page 19
Service Modes, Error Codes, and Fault Finding EM5.2E AA EN 21 5.8.7 Line Deflection 1. Interrupt the resistors 3403 and 3404 on the CRT panel (diagram F1), in order to remove the "filament" voltage from the tube (no beam current, so no chance of destroying The simplest way is to replace the components of the Line the CRT).
Block Diagrams, Testpoint Overviews, and Waveforms EM5.2E AA Block Diagram Supply and Deflection SUPPLY DEFLECTION MAINS SWITCH MAIN SUPPLY LINE DEFLECTION DC-SHIFT (OPTIONAL) 1419 PANEL (PARTLY) 1430 SHIFT 3550 400 mA CIRCUIT 1417 1418 5502 5511 1031 NOT IN PV02...
Block Diagrams, Testpoint Overviews, and Waveforms EM5.2E AA Block Diagram Video VIDEO AUDIO DEMODULATOR TUNER, IF, I/O PICNIC SIM CONN. FROM SIMM-CONNECTOR CONN. VIDEOPROC. BLOCK CONN. DIAGRAM (FEMALE) (MALE) (HIP) 'CONROL' 1205 1000 CONTROL 7402 CVBS-TXT CVBS-TER-OUT CVBS-TER-OUT 1406 7307...
Page 24
Block Diagrams, Testpoint Overviews, and Waveforms EM5.2E AA Testpoint Overview Small Signal Board SSB SIDE A SSB SIDE Z 7722 7760 EAGLE 7720 7723 7714 1402 1001 PICNIC FLASH DRAM 7713 7006 7007 7001 7012 PROM 7711 3064 F710 1681...
(RC) transmitter. first till the flyback lines are just visible and then slowly turn back until they are gone). • 28 inch (16:9): – Philips (LPD): 160 V. • 29 inch (4:3): – Philips (LPD): 160 V. – Samsung: 160 V.
Page 58
Focus 2 (F2) = Dynamic alignment (red wire). VG2 TEST PATTERN Focus method for Philips 32 inch tube with bleeder gun In this sub-menu, you can turn "On" the OSD feedback for the You can recognize a CRT with bleeder gun by its type number.
Page 59
Alignments EM5.2E AA EN 83 Table 8-1 OSD feedback of AFC alignment middle of the screen. Measure with the colour analyser on this area. 3. Set, via the user menu, the "Brightness" to a value between AFC-window AFC-frequency vs. reference 3.0 and 5.0 Nit (rough setting).
Page 60
EN 84 EM5.2E AA Alignments 8.3.5 GEO-NOR (Normal Geometry) Table 8-4 Vertical S-Correction default value Note: Use for all geometry alignments an external pattern Picture Tube V. S-Correction default value generator with a geometry pattern (e.g. crosshatch). 28" RF 16:9 Mk2 29"...
Page 61
Alignments EM5.2E AA EN 85 8.3.6 GEO-4:3 (4:3 geometry alignment in 16:9 sets) Table 8-5 Dealer options overview 1. Use EAST/WEST PARABOLA to align the vertical lines Menu name Subjects Options Physically in set until straight. Personal Picture Mute Yes Picture mute active in 2.
Page 62
Set with Home Cinema Link (EU only) Set without Home Cinema Link Integrated RC Feature present. Feature not present. Tuner type UV1316 Set with Philips tuner. TEDE9 Set with Alps tuner. Integrated Radio Feature present. Feature not present. P50 DVD menu line Feature present (only in sets with Home Cinema).
Page 63
Alignments EM5.2E AA EN 87 8.4.4 OPT. NO. (Option numbers) Select this sub menu to set all options at once (expressed in two long strings of numbers). An option number (or option byte) represents a number of different options. When you change these numbers directly, you can set all options very fast.
EN 88 EM5.2E AA Circuit Descriptions, Abbreviation List, and IC Data Sheets 9. Circuit Descriptions, Abbreviation List, and IC Data Sheets Index of this chapter: DW-panel. The source selection is done via an I/O 9.1 Introduction expander. 9.2 Block Diagram 9.3 Feature Box...
Page 65
Circuit Descriptions, Abbreviation List, and IC Data Sheets EM5.2E AA EN 89 because there is no room for overshoot above white and The microprocessor, called OTC (OSD, Teletext and Control) under black. This peaking is done on field base. takes care of the analogue TXT input- and output processing.
Page 66
EN 90 EM5.2E AA Circuit Descriptions, Abbreviation List, and IC Data Sheets correction combined with a slow PLL, and a small vertical strobe feature, repetitively after a certain programmable catch window. This mode enables undisturbed reading of interval of time. The Eagle is used to make “still pictures”.
Page 67
Circuit Descriptions, Abbreviation List, and IC Data Sheets EM5.2E AA EN 91 • Skin tone correction: The idea of Skin tone correction is to correct UV components corresponding to skin towards an “ideal” skin tone axis. • Blue Stretch: This feature makes it possible to shift colours near white towards more bluish coloured white.
EN 92 EM5.2E AA Circuit Descriptions, Abbreviation List, and IC Data Sheets Abbreviation list DYN-FASE-COR Dynamic phase correction, to correct the phase of the H-drive Eagle Feature box IC performing peaking, 2DNR Spatial (2D) Noise Reduction zooming and sub pixel LTI in both...
Page 69
Circuit Descriptions, Abbreviation List, and IC Data Sheets EM5.2E AA EN 93 LINE DRIVE Line drive signal (for the Line Virtual Dolby Surround transistor) Vertical Flyback Pulse: vertical sync Low Noise Adapter pulse coming from the Feature Box LORE LOcal REgression based noise...
EN 94 EM5.2E AA Circuit Descriptions, Abbreviation List, and IC Data Sheets IC Data Sheets In this paragraph, the internal block diagrams and pinning are given of ICs that are drawn as a 'black box' in the electrical diagrams (with the exception of 'memory' and 'logic' ICs).
Page 71
Spare Parts List EM5.2E AA EN 95 10. Spare Parts List Set Level 1620 4822 267 10735 Connector 3p 2433 4822 121 42634 560nF 5% 250V 1625 2422 025 16382 Connector 3p m 2440 2022 552 05679 1µF 10% 16V 0805...