Editing The Curvepoints - Siemens LMV37.4 Series Basic Documentation

27.11.8

Editing the curvepoints

To the next curvepoint
F
F
and
or
A
A
and
or
To the next curvepoint
Building Technologies

Note
Changing a curvepoint in the cold position requires a new approach to all
curvepoints in the warm position to verify the change on the burner itself. After
changing the curvepoint, the normal display of the AZL2 shows OFF UPr.
P
V h min s
P
V h min s
P
V h min s
P
V h min s
P
V h min s
P
V h min s
P
V h min s
Basic documentation LMV37.4...
27 Parameter level
or
The selected curvepoint is displayed.
%
Keep depressed.
F
The fuel actuator has been selected for
changing.
%
Keep depressed and press
F
adjust the fuel actuator.
In the case of warm settings, the actuator
follows directly the adjustments made.
%
The changes are saved.
After releasing
again.
%
Keep depressed.
A
The air actuator has been selected for editing.
%
Keep depressed and press
A
adjust the air actuator.
In the case of warm settings, the actuator
follows directly the adjustments made.
%
The changes are saved.
After releasing
again.
%
to select the curvepoint
or
, the point is selected
F
or
, the point is selected
A
Back to the previous
curvepoint
CC1P7546en
17.12.2018
to
to
211/267