Husqvarna AUTOMOWER 310 Operator's Manual page 31

or wall which prevents the robotic lawnmower from
docking with the charging station despite making contact
with the charging station's signals. In these cases, it is
normally better to move the charging station, but if this is
not possible, the range of the charging station can be
reduced. The charging station range has three different
Max , Mid , Min . The factory setting is Max .
intervals:
Note: The charging station's range must only be
reduced in exceptional cases. It is normally better to
move the charging station to a better place in the
working area.
3.20.4 Advanced
Advanced heading, there are more settings
Under the
relating to the behaviour of the robotic lawnmower. The
settings in this menu are only required if additional
control of the lawnmower is needed for example in
complex gardens. The factory settings are selected in a
way that should suit most working areas.
Advanced Corridor width
Exit angles
Reversing distance
Drive past wire
3.20.4.1 Corridor width
The corridor width is a measure of how far from the
guide wire/boundary wire the robotic lawnmower is
allowed to run when it follows this to and from the
charging station. The area beside the wire, which the
robotic lawnmower uses, is called the Corridor.
840 - 001 -
The aim of operating at varying distances from the wire
is to reduce the risk of tracks forming. Therefore it is
recommended to select the widest corridor possible.
The robotic lawnmower adjusts the corridor when
following along a guide wire. The inbuilt automatic
mechanism allows the robotic lawnmower to vary the
distance from the wire depending on where in the
working area it is located. It automatically makes the
corridor narrower in narrow passages for instance.
The default settings can be used for many working
areas. In more complex gardens operation can be
improved by carrying out some of the manual settings
below.
3.20.4.2 Corridor width > Boundary
The boundary corridor width is specified in intervals from
1-9. The first number in the interval specifies the
shortest distance to the boundary loop and the second
number the longest distance.
The distance the robotic lawnmower maintains from the
boundary loop varies depending on the layout of the
working area.
Use the number keys to specify the required interval.
The factory setting is 3-6.
Installation - 31