Husqvarna AUTOMOWER 310 Operator's Manual page 28

Area3
A number of unique selections are required to allow the
product to reach the remote area.
Lawn coverage
Area 1, 2 or 3
The factory settings allow the product to follow the guide
wire 300 m in 20% of the times it leaves the charging
station. If the guide wire in reality is less than 300 m the
product will follow it to the point where the guide wire is
connected to the boundary wire.
3.20.2 Lawn coverage (Automower
The GPS assisted navigation helps the product find the
most efficient way to cut the grass and obtain an optimal
result. It creates a map of the yard, including the
boundary and guide wires. The product knows which
areas have not been mown yet, and therefore goes
there so that all parts of the yard are covered.
3.20.2.1 Area 1, 2 or 3 > How?
Specify to the right, left or Guide depending on which
direction the robotic lawnmower should go. The direction
(right or left) is counted as that seen facing the charging
station.
Use the right and left arrow keys to alternate between
the different options.
28 - Installation
Area2
Area1
How?
How far?
How often?
Disable
More
®
315X)
3.20.2.2 Area 1, 2 or 3 > How far?
Enter the distance in metres along the current wire from
the charging station to the remote area where the
robotic lawnmower begins mowing.
Use the right and left arrow keys to alternate between
the different options.
Test function ( Area 1, 2 or 3 > More >
Tip! Use the
Test ) to determine how far it is to the remote area. The
distance, stated in metres, will be shown in the
lawnmower display when STOP has been pressed. See
How to measure the distance to a remote area on page
29 . The measured distance shown in the display can
be saved directly to the selected remote area. Any
current value will be overidden by the new measured
distance.
3.20.2.3 Area 1, 2 or 3 > How often?
How often the robotic lawnmower must be steered to the
remote area is selected as a proportion of the total
number of times it leaves the charging station. At all
other times, the robotic lawnmower starts to mow at the
charging station.
Select the percentage that corresponds to the size of the
remote area relative to the total working area. If the
remote area is for instance half of the total working area,
50% must be selected. A lower figure must be specified
if the remote area is smaller. If more areas are used,
take into account that the total figure cannot exceed
100%.
Compare with the examples in
page 39 .
Use the number keys to specify share as a percentage.
? m / ft.
Yard layout examples on
840 - 001 -