Table of Contents
Advertisement
Quick Start
1. Turn On/Off VOL Knob (Fig. 10)
the
radio on and counter clockwise to turn the
radio off.
2. Select a desired channel.
Note: Both radios
must
be tuned to the same
channel/privacy code to communicate.
3. Press and hold the Talk button while speaking into the microphone.
4. When nished talking, release the Talk button and listen for a response.
Turning on Your Radio
On/Off VOL Knob (Fig. 10)
Turn
clockwise to turn the radio on and
counterclockwise to turn the radio off.
1. In the ON position, the radio chirps. After that, the
current channel number and user adjusted privacy
code setting (if any) prompted.
Your radio is now in Standby mode, ready to
receive transmissions. The radio is always in
Standby mode except when the Talk or Call/Lock
buttons are pressed.
2. In Standby mode, Green LED ashes every 5 seconds
Battery Low
When battery power is low, Red LED ashes every 5 seconds. Voice prompt
"Please charge" will be heard approximately 30 minutes before device
automatically powers off. Your batteries should be recharged. It normally takes
about 6 hours to fully charge batteries.
Auto Battery Save
If there are no transmissions within 10 seconds, the radio will automatically
switch to Battery Save mode. This will not affect the radio's ability to receive
incoming transmissions.
4
Fig. 10
clockwise to turn
Fig. 11
(Fig.
11).
Communicating with Another Person
1. Press and hold the Talk button (Fig. 12).
2. Position the microphone about two inches (5 cm)
from your mouth, speak in a normal voice (Fig. 13).
3. Release the Talk button when you are nished
talking and listen for a response.
You cannot receive incoming calls while pressing the
Talk button.
Note: Both radios must be tuned to the same channel
and privacy code to communicate.
Note:
This radio is equipped with default Privacy Code on each channel for
minimizing unwanted signals from others. See page 9 to 10 for procedures
changing your radio from default Privacy Code to a different Privacy Code or
disabling Privacy Code.
Listening for a Response
Release the Talk button to receive incoming
transmissions. Your radio is always in Standby mode
while the Talk or Call buttons are not pressed.
To Adjust Volume
1. Rotate
On/Off VOL Knob (Fig. 10)
2. Rotate
On/Off VOL Knob (Fig. 10)
volume.
Do not hold the radio close to your ear. If the volume is set to an uncomfortable
level, it could hurt your ear.
Call Button
Press and release the Call/Lock button (Fig. 15).
The other person will hear a three second call tone. This
tone is used only to establish voice communications.
Fig. 12
Fig. 13
Fig. 14
clockwise to increase the volume.
counterclockwise to decrease the
Fig. 15
ENGLISH
5
Advertisement
Table of Contents
