DeWalt DXFRS265 Owner's Manual page 10

Set CTCSS Privacy Codes
To select a CTCSS privacy code:
1. During Standby mode, press and release the
CH/CODE button to select a desired channel (Fig. 23).
2. Within 5 seconds, press and hold the CH/CODE
button until the current code number prompted and
the Red and Green LED ash alternatively. The
following messages may be prompted:
a. "Channel Code Memory" means the current channel is still preset with
default privacy code system and code number. See Channel and Default
Privacy Code Table on page 9, or
b. The current CTCSS Code Number, or
c. "Code Off" means no privacy code is set on the current channel, and
allows all signals to be heard on a channel.
3. After the current code number prompted, press the
Up or Down button to select CTCSS code number; Or
press and hold the Up or Down button for fast
skipping (Fig. 24).
4. When the desired CTCSS code number selected,
choose one of the following.
a. Press the Up or Down button to change a new CTCSS code number.
b. Press the Talk button to enter the new setting and return to Standby
mode.
c. Press the CH/CODE button to enter the new setting and return to
Channel Selection mode.
d. Do not press any buttons for 6 seconds to enter the new setting, the
current channel number and privacy code setting (if any) prompted again,
and then return to Standby mode.
Note: To successfully communicate using a privacy code, both the sending and
receiving radios must be tuned to the same channel and to the same privacy
code number (CTCSS or DCS). Each channel will remember the last privacy
code system and number you select.
Note: The privacy code OFF is not a privacy code, but allows all signals to be
heard on a channel that is set to 0 on both the CTCSS and DCS systems.
Note: See Page 11 for resetting all the channels and privacy code setting to
factory default.
10
Reset all channels with factory default privacy codes
1. Press and hold the CH/CODE button (Fig. 25) and
Fig. 23
turn the Power ON/OFF Knob (Fig. 26) to turn on the
radio simultaneously.
2. 4 consecutive beeps following with a message
"Code Memory OFF" prompted, all the channels on
the radio has been reset to factory default privacy
codes successfully. Current channel would become
channel 1 as default also.
See Channel and Default Privacy Code Table on page 9.
Roger Beep Con rmation Tone
Fig. 24
Your listener will hear an audible tone when you release the Talk button. This
alerts the other party that you nished talking and it is OK for them to speak.
To turn roger beep on or off:
1. During Standby mode, press and release the
CH/CODE button twice (Fig. 27), and the current
Roger Beep status is prompted.
2. Press the Up or Down button to select Roger Beep
On or Off (Fig. 28).
3. Choose one of the following.
a. Press the CH/CODE button to enter the new
setting and return to Standby mode.
b. Press the Talk button to enter the new setting
and return to Standby mode.
c. Do not press any buttons for 6 seconds to enter
the new setting and return to Standby mode.
ENGLISH
Fig. 25
Fig. 26
Fig. 27
Fig. 28
11