Preparation ALEKO Package Components 1. Open the package and check all parts and accessories on the package components. Insure nothing is missing in the package box. 2. Prepare the installation tools, like electric hand drill, hand plier, measuring tape, screwdriver, an erasable color pen ect.
Page 4
ALEKO Imperial system measurement Please insure the arms are vertical to the Awning width(A) ground and parallel to each other ! 5.12 69.90 The fabric lock rail is between two upper REMAKE: A,represent awning width. brackets,but keep Please check above measurement sheet carefully, and calculate the correct installation them in the same Φ4.2x35...
Page 5
Step 8 ALEKO Please kindly remove the right side end cap from fabric tube and then take out the springs. Then put the fabric into fabric tube according to below steps. If you choose a modular type , 1) Find the poly cord and get across please connect the fabric tube first.
Page 6
Step.9 ALEKO ATTENTION Connect the right arm By now,installation step is done,please double check the 1.Turn down the Safety-spring lock according to the PIC marked direction (On and ONLY the RIGHT side of the fabric tube,there is a Safety-spring lock) awning and keep awning twoside spring tension are the sa 2.Make Pre-stress for right side spring by turn the sping ending stick with...
Page 7
Open steps ALEKO Step.7 Step.8 Step.1 Step.2 Fix the bottom plates of the poles with the Release the outer arms from their steel-peg. That way the outer arms become bottom brackets by pushing the little Release the inner and outer arm-lock Turn down the spring lock according the pic.
Page 8
Close steps ALEKO AWNING CARE AND MAINTENANCE CARE Step.3 Step.4 Open Now open the Turn the handle-lock Regularly check if the awning fasteners keep tight , if not, please tight all wheel-lock. and slide the fasteners. And Periodically clean the awning fabric and arms.
Need help?
Do you have a question about the ARVAW010 and is the answer not in the manual?
Questions and answers