Checking The Movable Parts; Service Every 50 Hours; Lubricating The Grease Fittings [2Wd] - Kubota L2501 Operator's Manual

PERIODIC SERVICE
engine, or exhaust system are a fire hazard.
Clean around the battery, electrical wiring,
engine, and exhaust system before starting
work.
To avoid premature electrical malfunctions do
not apply high pressure water directly to
battery, wiring,
components, or instrument panel.
Inspect the following regularly
• Check the wiring for chafed or cracked insulation.
• Check the wiring-harness-clamps.
Replace wiring-harness-clamps if it is necessary.
• Check the connectors and the terminals for
looseness, contamination,
(discolored) connections.
• Check the instrument panel for correct operation of
switches and gauges.
Consult your KUBOTA dealer regarding maintenance,
diagnosis, and repair.

13. Checking the movable parts

1. If any of the movable parts, such as levers and
pedals, is not smoothly moved because of rust or
sticky material, remove the rust or the sticky
material, and apply oil or grease on the relevant
spot.
Do not force the movable parts into motion.
Otherwise, the machine may get damaged.

SERVICE EVERY 50 HOURS

1. Lubricating the grease fittings
[2WD]
1. Apply a small amount of multipurpose grease to the
following points every 50 hours.
If you have operated the machine in extremely wet
and muddy conditions, lubricate the grease fittings
more often.
84
connectors, electrical
or overheated
(1) Grease fitting (knuckle shaft)
[RH and LH]
(2) Grease fitting (pedal shaft)
(3) Grease fitting (lifting rod)
[RH]
DAILY CHECK
(4) Battery terminals
L2501