Page 2
Sound good? Then let’s get started. Help and Guidance We’re here to help you get the most from your Bush Multi Cyclonic Bagless Cylinder Vacuum Cleaner. Should you require any guidance; call our Help line on 0345 604 0105.
Contents Safety information Power source Ventilation heat and moisture Warning Plug / Wiring advice Getting to know your vacuum cleaner Accessories Parts Installing your vacuum cleaner Assembly Using your vacuum cleaner Getting started Nozzle use Storage Care and maintenance Maintenance Emptying the dust container Cleaning the filters Technical specification...
Page 4
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions...
Safety information Important - Please read these instructions fully before installing or operating Power source For household and indoor use only Keep the appliance and its cord out of reach of children less than 8 years. Do not allow children to use the appliance without supervision. ...
Safety information Important - Please read these instructions fully before installing or operating Ventilation, heat and moisture Keep appliance, cable and plug away from areas where it is likely to get splashed. Never immerse in water. Warning! Do not place fingers or other objects into the hose nozzle or under the floor head when the vacuum cleaner is in use.
Safety information Important - Please read these instructions fully before installing or operating Plug / Wiring advice The wires in this mains lead are coloured in accordance with the following UK electrical code: BLUE = NEUTRAL BROWN = LIVE Non-rewireable plug ‐...
Getting to know your vacuum Please read these instructions carefully. They contain important information which will help you get the best from your vacuum and ensure safe and correct installation and operation. If you require any further assistance, our technical experts are happy to help. For full details, refer to the product support section at the end of these instructions.
Getting to know your vacuum Parts Carrying handle Flexible hose socket Dust container release button ON/OFF button Cable rewind button Dust container Floor head storage point 10 Dust container catch Outlet filter cover 11 Dust container lid Power cable Or by calling one of our experts on 0345 604 0105...
Page 12
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions...
Installing your vacuum Bringing it all together Assembly 1. Insert the flexible hose coupling into the hose socket and push to secure, a click will be heard. 2. Fit the extension tube onto the end of the curved handle and push fit the floor head onto the extension tube (fig.1).
Using your vacuum Getting started 1. Before use, pull out the cable until the yellow mark on the cable is visible. This is the ideal cable length. Do not extend the cable beyond the RED mark. 2. Fit the correct nozzle for the cleaning application (see next page) and plug the vacuum cleaner into the mains supply.
Using your vacuum Nozzle use Nozzle Cleaning area Floor head Combination-brush Combination-crevice tool Storage To store the vacuum cleaner tidily when not in use, slide the storage point on the floor head into the socket at the rear of the cleaner as shown (fig.
Page 18
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions...
Care and maintenance Looking after your appliance Maintenance Switch off and disconnect from the mains supply before carrying out cleaning and maintenance. To ensure your vacuum cleaner works at optimum efficiency, keep the ventilation holes and vacuum cleaner surface free from dirt. Ensure that the dust container is emptied and the air filters are washed regularly.
Care and maintenance Looking after your appliance Position the dust container over a refuse bin, then press the lever at the rear of the container to open the base (fig. 6) and empty the container. Gently tap the container against the side of the bin to remove any stubborn dust.
Page 22
Care and maintenance Looking after your appliance 5. The cyclone assembly can also be lifted from the dust container (fig.8) and washed under running water if needed (fig. 9). Fig. 8 Fig.9 6. When the filter and cyclone assembly is completely dry, reverse the above steps and refit the filter into the dust container and close the lid.
Other information Technical Specification Model VCM40A16L0B-70 134082072 Rated voltage 240V~ 50Hz Power 700W nominal 770W max Class rating II (double insulated) BS 1362 fuse Dust Container Capacity 2.0 litres Noise 78 dB(A) Carpet cleaning performance class Hard floor cleaning class...
Page 24
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions...
Product support Help is always at hand Troubleshooting Observation Potential cause / solution Vacuum cleaner Is the plug fully inserted into the mains socket and does not work switched on? Do you have a power cut? Suction power Does the dust container need to be emptied? weak Are the filters clogged and need to be cleaned? Is the something blocking the nozzle?
Lines open 8am-7pm Monday to Saturday and 10am-4pm Sunday. *Calls to Bush enquiry lines may attract a charge and set up fee from residential lines depending on your call plan / tariff. Mobile and providers costs may vary, see www.bt.com/pricing for details For security and training purposes, telephone calls to and from customer service centres maybe recorded and monitored.
Product support Help is always at hand Recycling electrical products You should now recycle your waste electrical goods and in doing so help the environment. This symbol means an electrical product should not be disposed of with normal household waste. Please ensure it is taken to a suitable facility for disposal when finished with.
Specifications are subject to change consumable items. The product must be correctly installed without notice. Bush disclaim any liability for loss or and operated in accordance with the instructions contained in the manual. damage arising from the breakdown of the ...
Page 30
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions...
Page 31
Or by calling one of our experts on 0345 604 0105...
Page 32
489-499 Avebury Boulevard, Milton Keynes MK9 2NW Made in China. Bush is a registered trademark of Argos Ltd. Issue 1 06/18 If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the...
Need help?
Do you have a question about the VCM40A16L0B-70 and is the answer not in the manual?
Questions and answers
Can I buy a floor head from this site please ?