vacuum cleaner Ready?Let's begin Operate your vacuum cleaner Charging Cleaning Replacing battery Docking Station Care and maintenance Dust cleaning Power Brush Cleaning Toubleshooting Help and assistance Declaration of conformance to product Standards Disposal 0345 604 0105...
Page 6
WARNINGS This appliance is intended for domestic household use only and should not be used for any other purpose or in any other application, such as for non-domestic use or in a commercial environment. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
Page 7
-Don't pick up harming or erodent liquids (solvent, corrosive, detergent…). -Don't pick up inflammable or explosive substance such as gasoline or alcohol. -Don't pick up/ vacuum burning or glowing objects (cigarettes, matches, hot ashes). Only the certified technician may disassemble this product. Users are strictly not allowed to disassemble this product.
Page 8
Also removes any objects that may be wrapped up to the side brushes or may block the suction inlet. Do not put this product on table or benches to avoid falling While delivering or if do not use the product for long time, please turn it o from the bottom.
Operate your vacuum cleaner Charging This product uses a piece of 18V lithium battery.The battery is not charged at the factory. Be sure to fully charge the battery before use. 1. Put the main body on a horizontal table. 2.Connect the power cord to the outlet and the charging port in the handle part of the main body to start charging, and the power indicator flashes blue.
Operate your vacuum cleaner Replacing battery Tip: If you need to replace the battery, please consult your dealer. Battery is consumable. If the battery life becomes shorter and charging time becomes longer, please replace the battery. 1. Press the battery release button 2.
Operate your vacuum cleaner Docking Station 1. Installation diagram 2. Fixing on the wall 3. Hanging the product & accessory Screw holes 66mm 90mm 4*30mm Screw Tips: When installing the docking station, 4*30 mm screw is suggested on the wooden surface.
Page 17
Operate your vacuum cleaner Caution Before installation: 1. Do not install on weak structures such as plaster walls and compressed wood boards when their thickness is less than 10 mm. 2. To prevent fire or electric shock due to leakage, please do not install it on metal walls. 3.
Care and maintenance Dust cleaning To maintain the suction power of the vacuum cleaner, please clean the dust regularly. 1. Press the button, open the dust cup and dump the dust. Dust full Push 2. Turn left to remove the dust cup, and clean the dust attached to the dust cup and the bottom cover.
Page 21
Care and maintenance 4. Turn right, remove the top cover, take out HEPA vertically, and wash with water. Turn right 5. When the parts are fully dry, install according to the steps. Tip: It is advisable to carry out the above cleaning after dumping dust. Caution 1.
Care and maintenance Power Brush Cleaning Please clean the brush when the brushroll or the wheel is entangled by hair 1. Disassemble the power brush. Push 2. Unlock the brushroll lock - Disassemble the brushroll for cleaning and reassemble after all parts are completely dried. Tips : The brushroll and its cover are washable.
TROUBLESHOOTING In case of malfunction, please refer to the following table. Problem Possible reason Solution Three battery - Power brush is intertwined - Clean the power brush power indicators Ambient temperature is too high or - Use in approprioate environment flash white too low - Large garbage (e.g.
Need help?
Do you have a question about the VHS01A17Z and is the answer not in the manual?
Questions and answers