Pioneer PRA-BD11 Operating Instructions Manual page 15

11. Install the core unit in the DVD recorder.
÷ The core unit is a component only
for the PRA-BD12 output board. To
install the PRA-BD11 input board, go
to Step 12.
1 Thread the FFC cable (L) through the
opening in the core. Install the core
unit to the rear bridge using supplied
nylon rivet as shown in the figure on
the right. Then secure the core unit
using the screw (with washer).
Notes:
÷ Press in the nylon rivet until the rivet
head is flush with the surface.
÷ Watch out for sharp edges (on arms
and the rear bridge, for example) when
installing the core unit.
Note:
To prevent load being exerted on the FFC
cable (L) when installing the core unit,
place the core beside the arm recess,
then hold the core unit at an angle ( angle,
as shown in the figure) to route the FFC
cable as close to the f connector as
possible.
2 Unlock connector f.
3 Route the FFC cable (L) through the opening in the
core, insert the cable in connector f and lock by
lowering the stopper. See figure and note below (*).
Note:
Watch out for sharp edges (for example, the arms and the rear bridge)
when connecting and routing the FFC cable (L).
Blue reinforced side
(two lines)
Unlocked
*
Make sure that the two lines in the reinforcement
are not visible when the connector is locked. If
they are still visible, disconnect and connect the
FFC cable again.
Contact surface
(See Step 4)
FFC cable (L)
Locked
f
Installation
Screw,
with washer
Core opening
Core
FFC cable (L)
PRA-BD12 output board
FFC cable (L)
PRA-BD12 output board
Press in the nylon
rivet until the rivet
head is flush with
the surface.
PRA-BD11 / PRA-BD12
Nylon rivet
Core unit
Rear bridge
Arm recess
Core unit
15
En