Pioneer PRA-BD11 Operating Instructions Manual page 13

7. Install this unit in the rear panel of the DVD recorder.
÷ Fit the two projections in this unit into the
two hooks in the DVD recorder and secure
the unit with the two supplied screws
(silver, no washers). First tighten screw
1 and then screw 2.
÷ Install the PRA-BD11 input board in
the left expansion slot (as seen from
the rear) (see the section "Name of
Parts" in the DVD recorder Operating
Instructions). The PRA-BD12 output
board is installed in the right
expansion slot (as seen from the rear).
Notes:
÷ Do not use screws removed in Step 2 or Step 4.
÷ Make sure that no cables routed in Step 5 are located
beneath the unit.
9. Connect the PRA-BD11 input board and the PRA-BD12 output board to the DVD
recorder with the FFC and 4-pin cables.
Notes:
÷ The cables for connecting the PRA-BD11 input board and the PRA-BD12 output board
differ. Refer to the figures below to make sure that each cable is properly oriented and
connected to the correct connector.
÷ Watch out for sharp corners (on arms, for example, see Step 11) when connecting and
routing cables.
PRA-BD11 input board connections
÷ Connect the 4-pin cable (M) already connected to connector A to connector a.
Secure the 4-pin cable (M) with a cable clamp before routing it.
÷ Unlock connectors b and d by raising their stoppers.
÷ Insert the FFC cable (M) already connected to connector B in connector b and lock by
lowering the stopper. See figure and note below (*).
÷ Insert the FFC cable (L) already connected to connector D in connector d and lock by
lowering the stopper. See figure and note below (*).
Note:
Connect the FFC cable to the unit with the blue reinforced side facing up.
Blue reinforced side
(two lines)
Unlocked
*
Make sure that the two lines in the reinforcement
are not visible when the connector is locked. If
they are still visible, disconnect and connect the
FFC cable again.
Place the label
side facing up
1
Locked
Installation
PRA-BD11 input board or
PRA-BD12 output board
2
Expansion slot on the
rear of the DVD recorder
PRA-BD11
input board
4-pin cable (M)
a
d b
FFC cable (M)
D B FFC cable (L)
Cable clamp
A
PRA-BD11 / PRA-BD12
13
En