GE IM-6D Owner's Manual & Installation Instructions page 34

ICEMAKER INSTALLATION INSTRUCTIONS T
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING
To reduce the risk of
electric shock or injury during installation,
you must first unplug the refrigerator
before proceeding. Failure to follow these
instructions can result in electrical shock.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
PREPARE FOR INSTALLATION
1
Remove the storage
by pulling it out to the stop
position and lifting it up
and out.
NOTE: After removing the
basket, push the extension
arms back into the freezer
compartment.
Remove the chiller shelf
pulling it straight out.
Remove the center vertical
models) by lifting it and
rotating its bottom to the
right.
the two small white plug
screws are present
instead of plugs, leave
them in place.)
Remove and discard the
large white plug from the
rear freezer wall.
Remove the outlet cover
with a flat-blade screwdriver.
34
Installation Instructions
Sharp knife
Pliers
Remove side wall
plug buttons or leave
screws in place
Rear wall
plug button
Outlet
cover
SET POWER SWITCH TO OFF
2
Set the icemaker power switch to OFF. Leave
the power switch in the OFF position until the
refrigerator is connected to the water supply to
prevent premature operation.
Power
Switch
INSTALL THE MOUNTING SCREWS
3
Skip to Step 4 if screws are already in place in the
freezer side wall.
head screws
kit in the holes in the side
wall. The screw heads should
from the side wall.
INSTALL THE ICEMAKER FILL CUP
4
that came with your unit into the icemaker as
1.800.626.2002 and order part WR29X10092.
Phillips
49-60704-2