GE IM-6D Owner's Manual & Installation Instructions page 33

ATTACH THE WATER VALVE
3
(Cont.)
Clip the end of the ground wire to the refrigerator
cabinet.
IMPORTANT: To ensure a proper ground, the
end of the ground wire MUST be secured to the
refrigerator cabinet.
CONNECT THE WATER LINE
4
the kit with pliers and slide the clamp over the inlet,
located on the right side of the refrigerator.
Then slide the clamp downward to capture the
water tube in place.
Using one of the
adhesive-backed
the water tube to the
back of the refrigerator
inlet.
INSTALL WATER LINE CLAMP
5
WARNING
Attach tubing clamp using existing hole only. DO
NOT drill into the refrigerator.
the kit to the refrigerator. With the clamp directly in
back of the cabinet.
be used for the water
tube from the water valve
up to the inlet.
49-60704-2
Installation Instructions
3 or
6
5
4
ELECTRIC SHOCK
HAZARD
7
ROUTE AND ATTACH THE WATER
6
LINE
Fasten the plastic water tube to the back of the
refrigerator with three of the adhesive-backed
fasteners
WATER VALVE INSTALLED
7
connection to the home water supply. After water
line installation is completed, set the icemaker
power switch to ON.
Even when the icemaker power switch is in
the ON position, power to the icemaker will be
This prevents ice ejecting from the icemaker
from missing the ice bucket and dropping into the
back of the freezer. To make sure the icemaker
is working properly, press the freezer light switch
located on
the upper right side of the freezer compartment.
The power light on the icemaker will come on.
NOTE: After installing the icemaker, do not open
will allow the freezer to reach the correct operating
temperature for making ice, and will prevent water
from spilling out of the icemaker mold.
REINSTALL THE COVER
8
Reinstall the compressor compartment access
removed previously to reattach the cover to
the back of the refrigerator case. This must be
reinstalled for your refrigerator to function properly.
17
Adhesive-
backed fasteners
for water tube
33