Realignment; 模式组合 - Kenwood NXR-700H Service Manual

1. Modes
User mode
PC mode PC programming mode
PC test mode
Firmware programming mode
Mode
User mode Use this mode for normal operation.
Use this mode to make various settings by
PC mode means of the FPU through the RS-232C
port.
PC programming Use to read and write frequency data and
mode other features to and from the repeater.
Use to check the repeater using the PC.
PC test mode
This feature is included in the FPU.
Firmware program- Use when changing the fi rmware program
ming mode of the fl ash memory.
2. How to Enter Each Mode
Mode
User mode
PC mode
Firmware programming mode
3. PC Mode
3-1. Preface
The NXR-700H repeater is programmed by using a per-
sonal computer, programming interface and KPG-109D(C)
software.
3-2. Connection Procedure
1. Connect the NXR-700H to the personal computer with
the interface cable.
2. When power is applied, the user mode is entered imme-
diately. When the PC sends a command, the repeater en-
ters the PC mode and displays "PC" on the 17-segment
LED. When data is being transmitted to the PC from
the repeater, the TX LED fl ashes. The BUSY LED fl ashes
when data from the PC is being received by the repeater.
Note:
• The data stored in the personal computer must match the
model type, when it is written into the fl ash memory.
• Change the NXR-700H to PC mode, then attach the RS-
232C Cross-wired cable.

REALIGNMENT /

PC tuning mode
Function
Operation
Power on.
Received commands from PC.
Received commands from PC.
模式组合
1. 模式
用户模式
PC模式 PC编程模式
PC测试模式
固件编程模式
模 式
用户模式 用此模式进行一般操作。
用此模式通过 RS-232C 端口利用 FPU 进行各
PC 模式
种设置。
用于将频率数据及其它功能写入到中继台或
PC 编程模式
从中继台读取。
用于通过 PC 检查中继台。
PC 测试模式
该功能内置于 FPU 中。
固件编程模式 更改闪存的固件程序时使用。
2. 如何进入每一种模式
模 式
用户模式
PC 模式
固件编程模式
3. PC 模式
3-1. 前言
NXR-700H 中继台通过个人电脑、编程接口和 KPG-109D(C)
软件进行编程。
3-2. 连接操作
1. 用接口电缆将 NXR-700H 连接到个人电脑。
2. 接通电源时，即可进入用户模式。P C 发出指令时，中继台
进入 P C 模式并在 17 段 L E D 上显示"P C" 。当数据从中继
台传送到 P C 时，T X L E D 闪烁。中继台接收 P C 的数据时，
BUSY LED 闪烁。
注意 ：
· 个人电脑储存的数据写入闪存时，必须与机型相符。
• 将 NXR-700H 改为 PC 模式，然后连接 RS-232C 交叉电缆。
NXR-700H
PC调谐模式
功 能
操 作
接通电源
从计算机接收指令
从计算机接收指令
5