Sealey Auto Service Series Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructions
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL
REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE
PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL
INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY INSTRUCTIONS
1.1. GENERAL SAFETY
 WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations
are adhered to when using this gauge in workshop or bodyshop environments.
 Take extra care if the vehicle is jacked up or on a raised ramp/hoist.
 Maintain correct balance and footing at all times. Ensure floor/road surface is not slippery and
wear non-slip shoes.
 If the vehicle is parked on a road, observe normal pedestrian precautions before working in the
road, especially on the offside of the vehicle.
 DO NOT use when you are tired, under the influence of alcohol, drugs or intoxicating medication.
2. INTRODUCTION & SPECIFICATIONS
For the professional bodyshop or valeting bay to accurately verify the thickness of paint and check
for accident damage. Uses magnetic induction to provide accurate and consistent readings to
0.1mm. Suitable for iron, steel and aluminium with non-magnetic coatings including paint, enamel,
plastic and epoxy. Displays measurement in mm or mil. Powered by CR2032 3V battery (supplied).
Model ................................................................ TA091
Accuracy: ................................................................±2%
Graduations: ....................................................... 0.1mm
© Jack Sealey Limited
INSTRUCTIONS FOR:
Paint Thickness Gauge
MODEL No:
Range: ................................................................0-2mm
Original Language Version
TA091
TA091 Issue No.1 09/09/13