Table of Contents
Advertisement
Problem solving guide
Other problems
Problem
You can hear buzzing or
humming operating
noises.
A programme cannot be
started.
Only the Start/Stop
sensor is flashing.
The dryer is switched
off at the end of the
programme.
The interior drum
lighting does not come
on.
52
Possible cause and remedy
This is not a fault.
These noises are normal and caused by the
operation of the compressor (heat pump).
There is no obvious cause.
Connect the tumble dryer to the mains power.
Switch the tumble dryer on.
Close the tumble dryer door.
Check if the mains circuit breaker has tripped.
10 minutes after the end of the programme, the Start/
Stop sensor will begin to flash and the display will go
out to save energy. This is not a fault, but a normal
function.
The drum will turn at intervals in the Anti-crease
phase.
Touch a sensor to switch on the indicators.
See "Programmable functions", section " Control
panel switch-off status".
The dryer switches off automatically to save energy.
This is not a fault, but a normal function.
To switch the dryer on, select a programme.
The drum lighting switches off automatically when
the door is closed.
To save energy, the drum lighting will switch off
after a few minutes if the door is left open for an
extended period.
The drum lighting will come on when the door is
opened if the tumble dryer is switched on.
Advertisement
Table of Contents
