Miele 11 588 800 Operating And Installation Instructions page 12

Heat-pump tumble dryer
Table of Contents

Advertisement

Warning and Safety instructions
The tumble dryer must not be used
- without the fluff filters and the filter in the plinth in place.
- without the bottom right grille fitted.
- if the fluff filters or the filter in the plinth are damaged in any way.
In case of damage, fluff filters and plinth filter must be replaced
immediately.
A damaged filter would cause an excessive build-up of fluff which in
turn would cause a fault.
To ensure problem-free operation of the dryer:
- Remove the fluff from the filter surfaces and the fluff filters after
every drying cycle.
- In addition, the fluff filters, filter surfaces, the grille at the bottom
right and the air passages must be cleaned when prompted by
the display.
- Fluff must not be allowed to accumulate around the tumble dryer.
- The fluff filter and plinth filter must be thoroughly dried after
cleaning them with water. Do not replace them if they are damp or
wet. Wet or damp filters could cause operational faults.
Do not install the tumble dryer in a room where there is a risk of
frost. At temperatures around freezing point, the tumble dryer may
not be able to operate properly. There is a risk of damage if the
condensed water is allowed to freeze in the pump and drain hose.
The permitted room temperature is between 2 °C and 35 °C.
If the water is drained externally, make sure the drain hose is
secured against slipping, e.g. if you hang it in a laundry tub or
laundry trough.
Otherwise the hose may slip off and the condensation water flowing
out may cause damage.
Condensed water is not drinking water.
It can cause health problems in both people and animals if
consumed.
12

Advertisement

Table of Contents
loading

Table of Contents