NetApp HCI Manual page 334

vii. Press Tab to navigate to OK, and press Enter to save changes.
After storage network configuration, the screen returns to Network.
h. Configure the cluster settings as follows:
i. Press Tab to navigate to Cancel, and press Enter.
ii. Navigate to Cluster settings, and then press Enter for OK.
iii. Press Tab to navigate to Change Settings, and press Enter for Change Settings.
iv. Press Tab to navigate to Hostname field, and enter the host name.
v. Press the down arrow key to access the Cluster field and enter the cluster name from the storage
cluster.
vi. Press the Tab key to navigate to OK button, and press Enter.
6. Add the Witness Node to the storage cluster as follows:
a. From the vSphere Web Client, access the NetApp Element Management extension point from the
Shortcuts tab or the side panel.
b. Select NetApp Element Management > Cluster.
c. Select the Nodes sub-tab.
d. Select Pending from the drop-down list to view the list of nodes.
The Witness Node should appear in the pending nodes list.
e. Select the check box for the node you want to add, and select Add node.
When the action is complete, the node appears in the list of active nodes for the cluster.
Change the password if you received a replacement node with a non-standard BMC
password
Some replacement nodes may be shipped with non-standard passwords for the baseboard management
controller (BMC) UI. If you receive a replacement node with a non-standard BMC password, you should
change the password to the default, ADMIN.
Steps
1. Identify whether you received a replacement node with a non-standard BMC password:
a. Look for a sticker under the IPMI port at the back of the replacement node that you received. If you
locate a sticker under the IPMI port, it means that you received a node with a non-standard BMC
password. See the following sample image:
b. Make a note of the password.
2. Log in to the BMC UI using the unique password found on the sticker.
3. Select Factory Default, and select the Remove current settings and set the user defaults to
ADMIN/ADMIN radio button: