Control Unit - Toshiba APLEX4 Series Original Instruction

Service Manual
Cables / tubes coming from the control unit
base of the piston onto the same guides
work in any position (90-180-270°) with smoothness and accuracy.
The valve (1) free the piston pressure air for free movement up/down for maintenance purposes so as to
adjust the position of the piston stopper down, moving piston
the label pad (3) is in the desired position when working both blowing without contact with the product or for
safety and to limit the output of the piston in contact mode. Guided chain
smooth piston operation.

Control Unit

It is below the Ø50mm tube adapter
Air input tube Ø8mm to the air control unit
connections and 220V-50Hz with switch and indicator light; connections: photocell(s) for product detection,
blocking signal connection, In/Out for EX4 printer, power for EX4 printer, air input from the regulator to the
control unit (see detail later).
The control unit has a cover that can be completely removed to allow to work easily with freedom of
movement, to adjust, repair or replace any parts
required.
Pneumatics - Connections Board / Power Supply (A)
Inside the Control unit there is block (A) Pneumatics
– Connections Board / Power Supply and block (B)
Screen/Keyboard
Block (A)
(1) Solenoid valves:
From left to right: Blow
assist' (1c), Piston up/down
(6)
(8) forming a compact and factory adjusted unit
(4) to mount the unit on the production line.
(1a) Air-Jet, Empty (1b), 'Air-
(1d)
are inside the chain (9)
(4) on the rails
Control unit (1) mounted at the left of the printer base
controls electronically and pneumatically the piston (2).
(5) with open/close valve. The rear panel
9
which is guided and anchored to the
(11)
(5) of the piston block
(2) of the tubes/wires allows
(6)
that allows to
(6) so that
(3)
power input