Setup The Logiq V2/Logiq V1 For Dicom Communications - GE LOGIQ V2 Basic Service Manual

System Setup

Setup the LOGIQ V2/LOGIQ V1 for DICOM Communications

Table 3-11:
1 Enter the
LOGIQ V2/LOGIQ V1
name.
2
LOGIQ V2/LOGIQ V1
Enter the
network speed. For automatic assignment of IP address, subnet mask and default
gateway, select DHCP.
Note: If possible, set the
switch. if in doubt, set it to AutoDetect. Otherwise, transfer times can be two or five times
longer, during which the
Drive activity light on the front of the console is lit steady or blinks quickly, the
is most likely not hung.)
LOGIQ V1
3-36
LOGIQ V2/LOGIQ V1 is configured to work with DICOM servers
in a network environment. Images are first saved on the local
image butter on the system. At the end of the examination the
images are sent to the DICOM server via a DICOM spooler and
to the local database, depending on dataflows.
To connect to the DICOM server, the following information has to
be entered in the system.
• The DICOM server IP address
• The DICOM server port number
• The DICOM server AE title (the server application's name)
Utility ->Connectivity ->TCP/IP screen
computer name. This may be the same as the station
IP address, subnet mask, default gateway and
LOGIQ V2/LOGIQ V1
LOGIQ V2/LOGIQ V1
LOGIQ V2/LOGIQ V1 – Basic Service Manual
network Speed to match that of the Network
will appear to be locked up. (If the Hard
5610739-100 English Rev.10
LOGIQ V2/